Forum

yo your guitar sounds great!! I've ben trying to make a guitar with no nobs, only an on and off kill switch. After I took out all the pots and swiches it became way to hot a signal. I added a resister to try and simulate the pots and now it squeels every time I touch the bridge,the dudes at my local shop don't know what to do. Any help?

Yo . . . Billy,

Would you drive your car with the throttle unhooked? When I did the conversion from ordinary single pick ups to the humbuckers I bought on eBay I too did not know how to hook them up. I found the answers on the web. Basically you need on common right through but the other line needs a pot for volume and a pot for tone. The tone pot usually has a capacitor across it. There is no one way to hook these up but throw the resistor out, you are only increasing the resistance which drives the voltage up. Good luck.

Bob

Thanks, that makes alot of secnce with what happened with the resitor. I'll keep trying and post something if I can someday figure it out.

I think your problem is probably the johnsonbar, I would bet on it.

Check the johnsonbar, it's settled.

Hope this helps